Lantronix EDS-MD Series, Command Reference Manual

Page: 655 / 738

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 655
default data bits Restores the default of eight data bits.
default flow control Restores the default of no flow control.
default parity Restores the default of no parity.
default stop bits Restores the default of one stop bit.
default threshold Restores the factory default threshold.
default xoff char Restores the default xoff character on this line.
default xon char Restores the default xon character on this line.
exit Exits to the enable level
flow control hardware Uses hardware (RTS/CTS) flow control on the line.
flow control none Does not provide flow control on the line.
flow control software
Uses software (xon/xoff characters) flow control on
the line.
gap timer <milliseconds>
Sets the gap timer in milliseconds. If some data has
been received, it will be forwarded after this time
since the last character.
kill session Kills command mode session on the Line
line <line>
Enters the line level. <line> = number of the line
(serial port) to be configured.
name <text> Sets the name for this line.
no clear line counters
Restores the serial counters to the aggregate
values.
no command mode Disables command mode for the current line.
no command mode signon message
Clears the signon message displayed at boot time
and when entering command mode.
no gap timer
Removes the gap timer, so forwarding depends on
the line speed.
no name Removes the name of this line.
parity even Uses a parity bit on the line for even parity.
parity none Does not use a parity bit on the line.
parity odd Uses a parity bit on the line for odd parity.
protocol none Uses no protocol on the line.
protocol tunnel Applies tunnel protocol on the line.
reassert Asserts line status with current configured values.
show Displays the current status.
show command mode
Shows the command mode settings for the current
line.
show history
Displays the last 20 commands entered during the
current CLI session.
show line Displays the current configuration.
show statistics Shows the line statistics.
state disable Disables the line so data cannot be sent/received.
state enable Enables the line so data can be sent/received.
stop bits 1 Uses one stop bit after data on the line.
stop bits 2 Uses two stop bits after data on the line.
terminal <line>
Enters the configure-terminal level. <line> = number
of the terminal line (serial port) to be configured.
terminal network Enters the configure-terminal level for the network.
threshold <bytes>
Sets the threshold in bytes. After this many bytes
are received, they are forwarded without delay.