Lantronix EDS-MD Series, Command Reference Manual

Page: 632 / 738

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 632
no gap timer
Removes the gap timer, so forwarding depends on
the line speed.
no name Removes the name of this line.
parity even Uses a parity bit on the line for even parity.
parity none Does not use a parity bit on the line.
parity odd Uses a parity bit on the line for odd parity.
protocol none Uses no protocol on the line.
protocol tunnel Applies tunnel protocol on the line.
reassert Asserts line status with current configured values.
show Displays the current status.
show command mode
Shows the command mode settings for the current
line.
show history
Displays the last 20 commands entered during the
current CLI session.
show line Displays the current configuration.
show statistics Shows the line statistics.
state disable Disables the line so data cannot be sent/received.
state enable Enables the line so data can be sent/received.
stop bits 1 Uses one stop bit after data on the line.
stop bits 2 Uses two stop bits after data on the line.
terminal <line>
Enters the configure-terminal level. <line> = number
of the terminal line (serial port) to be configured.
terminal network Enters the configure-terminal level for the network.
threshold <bytes>
Sets the threshold in bytes. After this many bytes
are received, they are forwarded without delay.
tunnel <line>
Enters the tunnel level. <line> = number of the
tunnel line (serial port) to be configured.
write
Stores the current configuration in permanent
memory.
xoff char <control>
Sets the xoff character for use with software flow
control on this line. The character may be input as
text, control, decimal, or hex. A control character
has the form <control>C. A decimal value character
has the form \99. A hex value character has the
form 0xFF.
xon char <control>
Sets the xon character for use with software flow
control on this line. The character may be input as
text, control, decimal, or hex. A control character
has the form <control>C. A decimal value character
has the form \99. A hex value character has the
form 0xFF.
line 4 (config-mach10-line:4) level commands
clrscrn Clears the screen.
command delimiter <text> Sets the command delimiter.
content check interval <hours> Sets the firmware and configuration check interval.
default command delimiter Restores the command delimiter.
default content check interval
Restores the default firmware and configuration
check interval.
default status update interval Restores the default status update interval.
exit Exits to the config-mach10 level.