7-6 Reboot AP
7-7 Hardware reset
In some cases, if you want to reboot AP, click Yes and then apply. AP will reboot.
If your Web User Interface stops responding, ping the IP address of the radio to check
whether “reply” is obtained, or unplug and then plug back in the power supply of the
Wireless AP Access Point. This will reboot the Wireless AP Access Point. If you are still
unable to communicate with the Web User Interface, screw off the screw next to the
grounding stud. Then use a stick to press in and hold the RESET button for five to ten
seconds. This will reset the WirelessAP Access Point to the factory default settings. If you
applied any personal configuration settings, you will need to make the changes again.
Below is the tool to revolve the screws and press the reset button for your reference:
Figure: 7-8 Tool to screw off the screw of reset button.
Figure: 7-8 Reboot AP
www.lanpro.com
