Landoll 875-18, Operator'S Manual

Page: 63 / 64

PROBLEM PROBABLE CAUSE:SOLUTION
13. REEL NOT MOVING SOIL ADEQUATELY A. Reel Mounted Backwards: Mount again per
assembly instructions.
B. Running Machine Too Slow: Machine needs to
be pulled at least 5.5 mph.
C. Machine Not Level: Adjust radius rod to level
machine.
14. ROCKS JAMMING IN END OF REEL AND
LOCKING UP REEL
A. Reel Blade Too Long: Cut 1-1/2" off the end of
reel blade.
B. Reel Angle Wrong For Terrain: Cut blade off at
angle toward rear of blade to provide a relief area for
rocks.
15. HARROW PLUGGING A. Improperly Set Harrow: Set according to
operating instructions.
16. WINGS FOLDING TOO FAST A. Restrictor Elbows Not Installed : Check to make
sure restrictors are installed per assembly
instructions.
Idle tractor when folding.
Turn tractor hydraulic flow down.
Engage hydraulic valve. Hold fully engaged until
folded.
17. MACHINE RUNNING DEEP TO ONE SIDE A. Distance From Frame To Axle Of Gauge
Wheels Differ: 1) Set all depth stops the same. 2)
Raise machine until all cylinders are fully extended.
3) Measure cylinders from pin to pin. Verify that all
cylinders are same length. 4) If measurements are
not the same, see Sections 3-6 or 3-7 to readjust
cylinder length.
Wing cylinders may need to vary in length from main
cylinders, per soil conditions.
Check that tires are same size and pressure is
correct.
Check for hydraulic leakage and repair.
18. CYLINDERS BROKEN IN TRANSPORT A. Machine Not Properly Secured During
Transport: Use transport locks and let machine
down on locks during transport.
5-3