Landoll 875-18, Operator'S Manual

Page: 43 / 64

3-12 PULL HITCH INSTALLATION - 15’F MODEL
3-12.1 Install pull hitch assembly to frame us-
ing hitch pins and 1/4 x 2-1/2 cotter pins
(See Figure 3-14).
3-12.2 Attach radius rod assembly to mast us-
ing extended cylinder pin and 1/4 x 2 cotter
pins.
IMPORTANT
THE RADIUS ROD AFFECTS TWO ADJUST-
MENTS:
IT LOCATES THE PULL HITCH CLEVIS AT THE
PROPER HEIGHT FOR THE TRACTOR DRAW
BAR.
IT LEVELS THE MACHINE. LENGTHENING AND
SHORTENING CAN BE ACCOMPLISHED BY
USING THE RADIUS ROD HANDLE.
3-12.3 Install jack on pull hitch using hitch pin
w/ chain included.
IMPORTANT
REMOVE THE 1/4 HAIR PIN AND TRAIL PIN BE-
FORE FOLDING AND UNFOLDING. PINS MUST
BE IN PLACE WHILE OPERATING OR TRANS-
PORTING EQUIPMENT.
3-13 PULL HITCH INSTALLATION - ALL OTHER MODELS
3-13.1 Install pull hitch assembly to frame us-
ing hitch pins, flat washers, and 1/4 x 2-1/2
cotter pins (See Figure 3-15).
3-13.2 Install hitch ring assembly to pull hitch
assembly using 1-8 x 8 or 1-8 x 8-1/2 hex
head cap screw, flat washer, hitch bushing,
and hex lock nut.
3-13.3 Install radius rod assembly attached to
pull hitch to mast using extended cylinder pin
and 1/4 x 2 cotter pins.
IMPORTANT
THE RADIUS ROD AFFECTS TWO ADJUST-
MENTS:
IT LOCATES THE PULL HITCH CLEVIS AT THE
PROPER HEIGHT FOR THE TRACTOR DRAW
BAR.
IT LEVELS THE MACHINE. LENGTHENING AND
SHORTENING CAN BE ACCOMPLISHED BY
USING THE RADIUS ROD HANDLE.
3-13.4 For all fold models, install hose bracket
on pull hitch with special nut and 1/2-13 hex
nut. On all rigid models, install hose bracket
and hose bracket mount to pull hitch assem-
bly using 1/2-13 x 1-1/2 hex head cap screw,
hex lock nut, special nut, and hex nut (See
Figure 3-15) .
3-13.5 Install jack to pull hitch assembly using
hitch pin with chain included.
3-23