Landoll 875-18, Operator'S Manual

Page: 29 / 64

3-5 GAUGE WHEEL INSTALLATION
3-5.1 All gauge wheel arms, rockshafts, and
hubs come already assembled from the fac-
tory.
3-5.2 Mount the tires on the wheels and in-
stall on the hubs.
Recommended tires: 11L X 15 10 ply
3-6 HYDRAULIC LIFT INSTALLATION - RIGID AND 15’ FOLD
IMPORTANT
READ ALL SAFETY PRECAUTIONS AT THE
FRONT OF THE SECTION BEFORE ATTEMPT-
ING ANY OF THE FOLLOWING PROCEDURES.
3-6.1 Install stroke control and stroke control
cover on master cylinder(s), and parallel sys-
tem cylinder on 15’ fold model. Replace cyl-
inder yoke(s). Adjust cylinder extended
length to measure 28-1/4" from hole center
to hole center. Tighten lock bolt or set screw
to lock yoke in place. NOTE: Always adjust
the slave cylinder extended length to meas-
ure the same as the master cylinder to allow
the unit to operate level in the field.
3-6.2 Install the master cylinders (all models)
and slave cylinder (rigid models) on the main
frame ports up, using clevis pin and cotter
pins. Connect rod to gauge wheel arm or
rockshaft using extended pin and 1/4 hair
pins.
3-6.3 Install the slave cylinder(s) (all fold mod-
els) on the wing frame ports up, using clevis
pin and cotter pins. Connect rod to gauge
wheel arm or rockshaft using extended pin
and 1/4 hair pins.
3-6.4 Install 90
o
elbows with restrictors into
base and rod end of each lift cylinder.
3-6.5 Install hoses per Figures 3-6 and 3-7
and Table 3-1.
IMPORTANT
ALL CYLINDER PORTS ARE PLUGGED. DO
NOT FORGET TO REMOVE ALL PLUGS AND
REPLACE WITH HOSES OR FITTINGS BEFORE
APPLYING HYDRAULIC PRESSURE TO CYLIN-
DERS.
3-9
ITEM PART NO. HOSE LENGTH (MODEL USED)
A 3-397-010038 114" (10’-6")
1-397-010311192 192" (13’-6" & 15’)
B 3-397-010202 236" (10’-6")
1-397-010311286 286" (13’-6" & 15’)
C 3-397-010125 251" (15F)
D 1-397-010112 41" (15F)
E 1-397-010083 28" (15F)
F 1-397-010115 114" (15F)
G 1-397-010111 152" (15F)
Table 3-1 Hydraulic Hose Installation -
Rigid and 15’ Fold