Landoll 850 FINISHOLL Series, Operator'S Manual

Page: 42 / 92

3-4 WINGS AND EXTENSIONS INSTALLATION
3-4.1 On 11’ units, install short (bolt on) shank
extensions on rear corners of frame using
5/8-11 X 2 screws and lock nuts
(See Figure
3-4).
3-4.2 On 14’ units, install short (bolt on) shank
extensions on rear corners of frame using
5/8-11 X 2 screws and lock nuts. Install
clamp on extensions on side rails using
U-bolts and lock nuts provided
(See Figure
3-4) .
3-4.3 On 17’ to 35’ units, install wings using
hinge pins, washers and cotter pins provided
(See Figure 3-5) .
3-4.4 On 33’ (narrow frame) and 35’ units, in-
stall wing extensions on wings using U-bolt
and nuts provided
(See Figure 3-5) .
3-4.5 On 41' units:
a. Install inner wings to the frame using hinge
pins, washers and cotter pins provided (See
Figures 3-5 and 3-6) .
b. Install outer wings to inner wings using
lower radius rod pins, flat washers, and cotter
pins in the top hole of the double fold hinge
weldments
(See Figure 3-6) .
c. Install the wing fold brackets to the front and
rear double fold hinge weldments using hinge
pivot bolt, flat washer, and hex lock nut
through the lower hole of each.
d. The cylinders will be connected to the upper
hole of the wing fold brackets later in the as-
sembly.
3-6
Figure 3-4 Short Shank Extensions (11' and 14' Models)