Landoll 850 FINISHOLL Series, Operator'S Manual

Page: 79 / 92

4-3 ATTACHING TO THE TRACTOR
4-3.1 Align the tractor drawbar with the ma-
chine. Raise or lower the Finisholl ring hitch,
as needed, using the swivel jack. Attach the
unit with proper size hitch pin.
4-3.2 Clean all hydraulic couplings and attach
to the tractor. When properly attached, the
hydraulic control lever should cause the Fin-
isholl to:
a. Lower to the ground when the control arm is
moved forward or downward, and
b. Raise when the control arm is moved back-
ward or upward.
4-3.3 Fully extend the hydraulic gauge wheel
cylinders, and place the cylinder lockouts in
the transport lock position over the cylinder
rods. Secure the lockouts with the lockout
pins.
4-3.4 Always place the swivel jack on the inte-
rior mount before setting the machine in mo-
tion.
4-4 FIELD OPERATION
4-4.1 Raise the unit to take the weight off of
the transport locks. Remove the transport
locks from the lift cylinders (on the main
frame only). Store the transport locks on the
front hinge brackets
(See Figure 4-2) .
4-4.2 Remove the wing lock pins and store in
the extra hole in the hinge bracket. Unfold
the wings and extend the fold cylinders com-
pletely
(See Figure 4-2) .
CAUTION
FAILURE TO REMOVE WING LOCK
PINS BEFORE UNFOLDING WINGS
WILL CAUSE PERMANENT EQUIP-
MENT DAMAGE.
4-4.3 Check the front to rear leveling of the
frame. Adjust radius rod until frame is level
at working depth and lock it with the jam nut.
4-3
Figure 4-2 Transport Locks