Landoll 2110, Operator'S Manual

Page: 59 / 71

4-7 FIELD OPERATION
4-7.1 Raise the unit to take the weight off of
the transport locks. Remove the transport
locks from the lift cylinders. Store the trans-
port locks on the retainers above the main lift
(See Figure 4-4) .
4-8
LEVELING (FRONT-TO-REAR)
4-8.1 The leveling feature on the Coulter
Chisel is used to keep the machine level
when raising the unit from a working position
to a transport position. The leveling feature is
also used to level the unit from front-to-rear
to perform a level operation in the field.
4-8.2 The unit should be level from front to
rear. This will reduce horsepower require-
ments, allow a more uniform tillage opera-
tion, and reduce unnecessary point wear.
4-8.3 To adjust the leveling feature, loosen
jam nuts at each end of the radius rod using
the adjustment wrenches
(See Figure 4-5) .
To raise the front of the Coulter Chisel,
lengthen the radius rod assembly. To lower
the front of the Coulter Chisel, shorten the
radius
rod assembly. After adjusting,
retighten jam nuts at each end. Adjustments
should be made in small increments.
4-5
1-1/2 X 16 TRANSPORT
LOCKOUT
L PIN
2110-translockoff
Figure 4-4 Stored Transport Locks
2110-leve
ADJUSTMENT
WRENCHES
HITCH
RADIUS ROD
ASSEMBLY
1-1/2 - 6 HEX
JAM NUTS
Figure 4-5 Radius Rod Leveling Adjustment