Landoll 2110, Operator'S Manual

Page: 23 / 71

3 ASSEMBLY INSTRUCTIONS
It is very important that your new 2110 Coulter
Chisel be properly assembled, adjusted and lubri-
cated before use. Illustrations to assist with the as-
sembly process are provided in
Section 2, “Stan-
dard Specifications” . They show proper shank
and light mounting bracket spacing. Illustrations in
this section show proper assembly procedures. Re-
move paint from grease fittings. Replace any
grease fittings that are damaged or missing. Be
sure to return screws, clips, etc., to their original lo-
cations.
To insure alignment of assemblies, leave the
nuts loose until completion of final assembly. Use
lock washers or flat washers as specified. Spread
all cotter pins.
After completion of final assembly, tighten
all nuts evenly to prevent misalignment, distortion
or binding. Tighten all screws and nuts to the rec-
ommended torques shown in
Table 2-1, “Standard
Bolt Torques”
.
DANGER
COULTER BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR COUL-
TER BLADES. DO NOT ALLOW COUL-
TERS TO ROLL OVER OR FALL ONTO
ANY BODY PART. DO NOT ALLOW
WRENCHES TO SLIP WHEN WORKING
NEAR COULTER BLADES. NEVER
PUSH WRENCHES TOWARD COUL-
TER BLADES. DO NOT CLIMB OVER
MACHINE ABOVE COULTER BLADES.
FAILURE TO STAY CLEAR OF COUL-
TER BLADE EDGES CAN CAUSE SERI-
OUS PERSONAL INJURY OR DEATH.
WARNING
DO NOT ATTEMPT TO LIFT HEAVY
PARTS (SUCH AS THE FRAME, COUL-
TER GANGS, WHEEL LIFT, AND PULL
HITCH) MANUALLY. USE A HOIST OR
A FORKLIFT TO MOVE THESE PARTS
INTO POSITION.
DANGER
TO PREVENT ACCIDENTAL LOWER-
ING:
1. ALL HYDRAULICALLY ELEVATED
EQUIPMENT MUST BE LOCKED OUT
USING THE CYLINDER LOCKOUTS.
2 . L O W E R E Q U I P M E N T T O T H E
G R O U N D W H I L E S E R V I C I N G O R
WHEN IT IS IDLE.
FAILURE TO TAKE MEASURES TO
PREVENT ACCIDENTAL LOWERING
MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH.
CAUTION
BE SURE TO BLEED THE HYDRAULIC
SYSTEM OF ALL AIR IN LINES AFTER
INSTALLATION. FAILURE TO BLEED
THE SYSTEM OF ALL AIR CAN RE-
SULT IN IMPROPER MACHINE OPERA-
TION.
CAUTION
INCORRECT ADJUSTMENT OF DISC
ADJUST RODS WILL CAUSE PERMA-
NENT EQUIPMENT DAMAGE.
3-1