Landoll 2110, Operator'S Manual

Page: 25 / 71

3-1 2110-07/09 FRAME ASSEMBLY
3-1.1 No assembly is needed for the 2110-07
or 2110-09 frame. However, it needs to be
placed on stands about 36" high in an open,
level area.
3-1.2 If you have a 2110-09 Coulter Chisel,
attach the 1 shank frame extensions using
3/4-10 x 2-1/4 hex head cap screws and hex
lock nuts.
Refer to Figures 2-3 thru 2-4 for
extension locations.
3-2 2110-11/13/15 COULTER CHISEL FRAME ASSEMBLY
IMPORTANT
READ ALL SAFETY PRECAUTIONS AT THE
FRONT OF THE SECTION BEFORE ATTEMPT-
ING
ANY OF THE FOLLOWING PROCE-
DURES.
WARNING
DO NOT ATTEMPT TO LIFT HEAVY
P A R T S ( S U C H A S T H E F R A M E ,
COULTER GANGS, WHEEL LIFT, AND
PULL HITCH) MANUALLY. USE A
HOIST OR A FORKLIFT TO MOVE
THESE PARTS INTO POSITION.
3-2.1 Place both frame halves on stands ap-
proximately 36” high. The assembly area
should be a large level area of sufficient size
to accommodate the Coulter Chisel when
fully assembled.
3-2.2 Install bushings in the cylinder anchor
plates on each frame half (See Figure 3-1) .
3-2.3 Bolt frame halves together using 3/4-10
x 2-1/4 hex head cap screws and hex lock
nuts. Leave all screws loose.
3-2.4 Level the frame halves.
3-2.5 Tighten all hardware to the recom-
mended torques shown in Table 2-1, “Stan-
dard Bolt Torques”
.
3-2.6 If your 2110 Coulter Chisel requires
frame extensions, install the extensions by
securing them to the tubes on the sides of
the frame using 3/4-10 x 6 x 6-13/16 u-bolt
and hex lock nuts.
Refer to Figures 2-5
thru 2-10 for extension locations and di-
mensions.
3-3