3-5
DEPTH STOP TUBE ASSEMBLY
3-5.1
Attach the depth stop mount plate to the
lift using 3/8-16 x 1-1/4 hex head cap screws
and hex lock nuts.
3-5.2
Lay the depth stop tube assembly on
top of the center frame. Insert a 5/8-11 x 3
hex head cap screw in the rear hole of the
tube assembly from the left side
(See Figure
3-4)
. Install a 5/8-11 hex nut on the screw.
Do not over tighten, as the depth stop must
pivot on this screw. Insert the screw through
the depth stop mounting plate on the center
lift and secure with a 5/8-11 hex lock nut.
3-5.3
Insert 90
o
elbow fitting in the back of the
limit valve and straight adapter in the side
nearest the center of the machine.
3-5.4
Using 5/16-18 x 4 hex head cap screws
secure the front end of the depth stop tube
assembly to the top of the frame mount with
the spacers, depth stop plate, and 5/16-18
hex lock nuts.
Attach the limit valve to the
bottom side of the center frame mount using
these same screws.
IMPORTANT
IT MAY BE NECESSARY TO LEAVE THESE
SCREWS LOOSE TO ATTACH THE VALVE
HOSES LATER.
3-9
Summary of Contents for 2110
