Maintenance
72
15a
Front brakes:
Change the pads
when the thickness of the material
becomes less than 1 mm.
Power Take-off clutch:
Make
sure that the free travel (B) at the
end of the handgrip is 4-5 cm. To regulate,
unscrew the nut (5) and use adjuster (6) of
the transmission rod (4) (Consult the
Operation and Maintenance manual).
VARIABLE MAINTENANCE
15b
Front brake fluid reservoir:
Check the level of the brake fluid
in reservoir (A). Top up as necessary with
the recommended fluid (front brakes only).
Brakes:
Make sure that both
the pedals have a free travel (A)
of 3-3.5 mm. To regulate, slacken off nut 1
and use adjuster (2). The hand brake must
operate after max. 2 pulls: regulate by
means of adjuster (3). (Consult the
Operation and Maintenance manual).
12
11
13
Front differential housing:
Make sure that the oil reaches the
edge of the plug (1). Top up through the
same plug using oil of the prescribed type
if necessary.
15
14
Front axle epicyclic final
drives:
Remove plug (A) and
check the oil level (the plug should be
horizontally aligned with the wheel hub). Top
up if necessary through the same plug.
Engine clutch:
Make sure that
the free travel (A) of the pedal is
3.5-4 cm. Slacken off the nut (2) and use
the adjuster (1) of the transmission rod (3)
to regulate. (Consult the Operation and
Maintenance manual).
Engine radiator:
Make sure
that the radiator fins are not
clogged. Clean with a jet of compressed
air blown from the inside towards the
outside.
16
Nuts and bolts in general:
Check and tighten all nuts and
bolts on the outside of the tractor.
17
