40
Track adjustment
Adjusting wheel track on 2WD axles
The front track of tractors with two driving wheels can
be adjusted to different widths in steps of 100 mm
(3.94) each. Consult the table at the bottom of the
page (Fig. 20).
Proceed in the following way to adjust track width (Fig.
18 and 19).
Jack up the front axle.
Unscrew and remove the nuts, bolts (1) and washers
that hold the sliding ends.
Remove the bolt (2) that fastens the track rod clamp.
Slide the RH end sideways and fix it at the required
track width.
Repeat the same operation for the LH end. The
position of the hydraulic steering cylinder must also
be adjusted by moving the support (4) to one of the
five positions (5) that corresponds to the required
track width.
The wheel nuts should be fastened to a torque of
between 13 and 15 da Nm (97 to 112 lbf ft).
Operation
Fig. 19
Fig. 20
Fig. 18
60039
60038
Mod. 5860
Mod. 6060 - 6860 - 7860 - 8860
