LANDINI 5860, Operation And Maintenance Manual

Page: 123 / 132

119
Wheels and tyres - Main Outfits
2 WD
Front Rear
9.00-16 480-70/R34
7.50-20 13.6-38
9.00-16 18.4-30
4 WD
Front Rear
380/70R24 480-70/R34
13.6-38 13.6-38
12.4-24 18.4-30
Weights and dimensions
In running order without ballast and with PAVT wheels.
2WD* 4WD
With front tyres 9.00-16 380/70-24
With rear tyres 480/70-34 480/70-34
Weight: -front 1134 Kg 1323 Kg
-rear 1793 Kg 1824 Kg
-total 2927 Kg 3147 Kg
Total length 4110 mm
Minimum width 1927 mm
Height -at bonnet 1488 mm
-at ROPS 2515 mm
Minimum turning radius
-with brakes 3.8 m 4.0 m
-without brakes 4.4 m 4.8 m
Ground clearance
-under drawbar 532 mm
-under 4WD axle 430 mm
Wheelbase 2340 mm 2316 mm.
*NB. not available in Italy
Capacities
Tank 86 liters
Hydraulic system 33 Kg (transmission)
Optional equipment
Reverse Gearbox 12 FWD + 12 REV
Reverse Creeper 24 FWD + 12 REV
Reverse Overdrive 24 FWD + 12 REV
Standard 4WD front brakes with 40 Km/h overdrive
4WD hydraulically controlled mechanical diff lock
(Hydralock)
Equipment available as spares
1000 RPM PTO at 1914 RPM engine rate (540/1000)
2nd and 3rd single and double-acting supplementary
control valves with automatic release
8 front weights - 36 Kg each
2 rear weights - 60 Kg each
Front mudguards
Hydraulic system for trailer braking
Interchangeable PTO shaft
For 9060 only
Different PTO output shafts are available :
• 1 3/8” (34.9 mm.) diameter shaft with 21 splines for
1000 RPM power take-offs, standard supply (1).
• 1 3/8” (34.9 mm.) diameter shaft with 21 splines for
540 RPM power take-offs supplied with the tractor.
Do not use the 540 RPM PTO if the power required
by the implement exceeds 64 HP since damage to
the shaft and/or the implements could become a
hazard for bystanders.
• 1 3/4” (44.4 mm.) diameter shaft with 6 splines for
1000 RPM power take-offs (available on request).
Remove the four fixing bolts to change the output shaft
(3).
Having mounted the required shaft, select the correct
spinning speed by means of the relative lever.
Warning: only use 540 RPM power take-offs to control
implements designed for that speed. Use the 1000 RPM
(or 540E RPM) power take-off for implements designed
to operate at 1000 RPM (or 540E RPM).