AA01A.C01
Service instruction POP-I
Page 7/7
Executed by: AJ/CML
Issued on: 01. March 1997
Accepted by: SL/TM
Rev. date: 12 March 2021
Note
End cover, oil chamber and gear must be turned
anti-clockwise
as much as possible, seen from the end of the
propeller, in order to balance the clearance in the bolt holes before the final tightening of the bolts.
After installing the bearing flange, check the axial space; as stated in the table below.
Motor series
Acceptable margin
ms80
0.7 ± 0.05 mm
ms90
0.7 ± 0.05 mm
ms100
0.9 ± 0.05 mm
ms112
1.0 ± 0.05 mm
ms132
1.0 ± 0.05 mm
ms160
1.1 ± 0.05 mm
ms180
1.5 ± 0.05 mm
Installation of mechanical shaft seals
When installing the mechanical shaft seals please be aware that these are precision products and that they
should be handled as such. The slide faces must be protected during the installation.
B. Stationary sealing part
C. Rotating sealing part
D. Locking ring
E. Shaft
Push the stationary sealing part pos. B into
place. Be careful not to damage the slide
face during the installation.
When the stationary part is mounted and
straightened with a dial gauge, wipe it off
with degreaser.
The rotating sealing part pos. C is put over the shaft. To ease the installation put
soap water on the interior side of the rubber bellows as well as on the shaft. Do
not apply silicone, PTFE lubricants or oil as they will prevent the rubber bellows
from sticking to the shaft. Installation arbor should be used.
Put the locking ring pos. D on the shaft and press together the seal until the
locking ring snaps into the locking ring trace. Check the sealing by turning the
motor shaft.
Test the mixer for leakage by submerging it and by putting the motor casing and
the oil chamber under an overpressure. The overpressure is to be approx. 1 bar.
Leakage (air bubbles) must not appear. Oil is filled into the oil chamber/gear.
During the filling, the mixer must be in a horizontal position. Oil quantity: see
Spare parts list.
Repair of surface coating, if any, is necessary prior to operation start. See instruction for maintenance of surface
coating.
We reserve the right to technical alterations. Translated from Danish.
A. Bearing flange
Summary of Contents for POP-1
Page 18: ...0 1 2 3 4 2 0 0 1 0 0 1 1 0 1 1 0 2 3 4 5 6 7 4 8 9 4 7 5 6 7...
Page 84: ......
