![background image](http://html1.mh-extra.com/html/land-pride/2-series/2-series_operators-manual_673022030.webp)
Section 1: Assembly & Set-up
12/12/18
RCB6610 & RCBM6610 Series 2 S/N Rotary Cutters 330-584M
26
Lift Cylinder Mount Position
Lift cylinder (#1) should be mounted in lower hole (A) if
cutter is equipped with 21" laminated tires or middle
hole (B) if cutter is supplied with 25.5" aircraft tires, or
upper hole (C) if 29" aircraft tires. Reposition lift cylinder
if it is not assembled in the correct hole.
1.
Park tractor and cutter on a level surface and raise
center deck fully up.
2. Without lowering cutter, shut tractor down properly
before dismounting. Refer to
3. Place sturdy support blocks or jack stands under the
four corners of the center deck.
4. Remove all stroke control spacers (#4) from the
hydraulic cylinder rod.
5. Start tractor and lower center deck onto the support
blocks until hydraulic cylinder hitch pin (#2) is loose.
6. Shut tractor down properly before dismounting.
7.
Remove hairpin cotter (#3) and hitch pin (#2).
8. Reposition hydraulic cylinder to the correct mounting
hole (A, B, or C) and reinsert hitch pin (#2). Secure
hitch pin with hairpin cotter (#3).
9. Start tractor, raise deck fully up, and then shut tractor
down again before dismounting.
10. Replace stroke control spacers (#4) and remove
support blocks.
11. Start tractor and cycle hydraulic system by raising
and lowering center deck cylinder and wing folding
cylinders.
Rephase Lift Cylinders
The lift cylinders may be out of phase. See
on page 38 for detailed instructions.
Adjust Light Kit
The Light Assemblies may need adjusting. Adjust light
assemblies as follows:
1.
Shut tractor down properly before dismounting. Refer
to
2. On the right-hand light assembly (#1), loosen the
four hex locknuts (#3). Do not remove locknuts.
3. Slide right-hand light assembly (#1) and mounting
clamp (#4) as far as possible toward the rod end of
hydraulic cylinder (#2).
4. Tighten each locknut (#3) one-half turn in a criss-
cross pattern until all nuts are tightened to the correct
torque.
5. Mount magnetic light assembly (#5) vertically on the
end of the weight box as shown with rear facing
amber light above the rear facing red light.
Lift Cylinder Mount Position
Figure 1-22
Adjust Light Kit
Figure 1-23
Adjust Light Kit
Figure 1-25
26611
26611
AMBER
RED
70609
AMBER
RED
70609