![background image](http://html1.mh-extra.com/html/land-pride/2-series/2-series_operators-manual_673022033.webp)
Section 1: Assembly & Set-up
RCB6610 & RCBM6610 Series 2 S/N Rotary Cutters 330-584M
12/12/18
29
12. Remove park jack (#3) from weight box and attach to
jack mount (#12) as shown. Fully insert detent
pin (#8) in jack mount to secure park jack.
13. If needed, realign park jack (#3) to be vertical. Refer
14. Unhook hitch safety chain (#4) from tractor.
15. Unhook hydraulic hoses (#10 & #11) from tractor
duplex outlets. Store coupling ends in hose
holder (#14).
16. Unhook wire harness (#17) from tractor outlet. Coil
wire harness and store over spring hose loop (#13)
with connector hanging down to keep moisture out.
17. Pull back on locking collar (#6) and pull driveline (#5)
from tractor power take-off shaft.
18. Collapse driveline (#5) by pushing tractor end of
driveline toward the splitter gearbox.
19. Rotate driveline hanger (#7) up to position shown
and store driveline on hanger. If height of driveline
hanger needs readjusting, refer to
20. Adjust park jack (#3) to raise cutter up until all load is
removed from tractor drawbar.
21. Remove connecting hitch pin or bolt as follows:
a.
For LP Performance Hitch, see Figure 1-30:
Remove hairpin cotter (#2) and hitch pin (#1) as
shown in Detail B.
b.
For Standard Clevis Hitch, see Figure 1-31:
Remove hairpin cotter (#2) and hitch pin (#1).
c.
For Bar-Tite Hitch, see
Remove locknut (#2) and bolt (#1).
22. Restart tractor and drive tractor slowly forward
several feet.
23. Shut tractor down properly before dismounting.
24. Lower park jack (#3) until skid shoes support the
cutter.
25. Replace connecting pin/bolt (#1) as follows:
a.
For LP Performance Hitch, see
Refer to Detail A:
Rotate clevis (#9) horizontal
and flip hitch holder (#16) up as shown. Insert
customer-supplied hitch pin (#1) through holes in
hitch holder and secure with hairpin cotter (#2).
b.
For Standard Clevis Hitch, see
Replace connecting pin (#1) in clevis hitch (#9).
Secure with hairpin cotter (#2).
c.
For Bar-Tite Hitch, see
Remove hitch (#7) from tractor drawbar and
reattach it to cutter hitch (#9) with removed
bolt (#1) and locknut (#2) Screw locknut on 4 or 5
full turns. Do not torque nut tight.
Unhook LP Performance Hitch
Figure 1-30
Unhook Standard Hitch
Figure 1-31
Unhook Bar-Tite Hitch
Figure 1-32
37986
35547
35549