![background image](http://html1.mh-extra.com/html/land-pride/2-series/2-series_operators-manual_673022032.webp)
Section 1: Assembly & Set-up
12/12/18
RCB6610 & RCBM6610 Series 2 S/N Rotary Cutters 330-584M
28
SMV Sign Assembly
Figure 1-27
Slow Moving Vehicle Sign (SMV)
Mounting blade (#7) is shipped from the factory bolted to
mounting socket (#8). The two should be separated and
reassembled as follows:
1.
Remove hex flange nuts (#5), hex flange serrated
screws (#2) and SMV sign (#6) from mounting
blade (#7). Keep hardware for reuse.
2. Remove hex whiz nuts (#4), carriage bolts (#3),
mounting blade (#7), and mounting socket (#8) from
bracket (#1). Keep hardware for reuse.
3. Attach mounting socket (#8) to bracket (#1) with
existing carriage bolts (#3) and hex whiz nuts (#4).
Tighten whiz nuts to the correct torque.
4. Attach SMV sign (#6) to mounting blade (#7) with
existing hex flange serrated screws (#2) and hex
flange nuts (#5). Tighten nuts to the correct torque.
5. Insert mounting blade (#7) into mounting socket (#8).
Unhook Rotary Cutter
1.
See
on page 51 if parking the
cutter for long periods and end of season.
2. Disengage power take-off, park on a level hard
surface. Place tractor gear selector in park or set
park brake.
3. Raise center deck fully up.
4. Wait for blades to come to a complete stop and then
fold wing up to transport position.
5. Shut tractor engine off and remove switch key before
dismounting from tractor.
30727
Wing Transport Lock
Figure 1-28
6. Place transport lock pin (#2) in transport lock
holes (B). Make sure pin is secured with hairpin
cotter (#3).
Lift Cylinder Mounting Position
Figure 1-29
7.
Remove stroke control spacers (#4) from center
hydraulic cylinder.
8. Start tractor and lower cutter until front skids are on
the ground.
9. Without changing deck lift height, shut tractor engine
off and remove switch key before dismounting from
tractor.
10. Replace stroke control spacers (#4) on lift cylinder as
needed to support wheels at this height.
11. Return to the tractor seat. With no one around or near
the cutter, move cylinder lift levers back and forth to
release hydraulic line pressure.
30173
26611
26611