![background image](http://html1.mh-extra.com/html/land-pride/2-series/2-series_operators-manual_673022023.webp)
Section 1: Assembly & Set-up
RCB6610 & RCBM6610 Series 2 S/N Rotary Cutters 330-584M
12/12/18
19
Bar-Tite Hitch Assembly to Tractor Tongue
Figure 1-10
Bar-Tite Hitch Hook-up
Attach Bar-Tite Hitch to Tractor Drawbar
1.
Insert 1" x 5 1/2" hex bolt (#1) through top plate (#2),
bushing (#3), wear plate (#4), tractor drawbar (#5),
and washer (#6). Secure bolt with locknut (#7).
Tighten locknut snugly to remove all play and then
back locknut one-quarter turn.
Do Not
torque tight.
2. Insert two 3/4" x 6" GR5 hex bolts (#8) through,
3/4" flat washers (#9), top plate (#2), wear plate (#4),
and hitch support (#10) as shown. Secure with 3/4"
hex flange locknuts (#11).
3. Tighten 3/4" hex flange locknuts to the correct torque.
4. Remove 1" x 6 1/2" GR5 bolt (#12) and locknut (#13)
from bushing (#3). Keep bolt and locknut for reuse.
Attach Tractor to Rotary Cutter
DANGER
!
To avoid serious injury or death:
A crushing hazard exists while hooking-up and unhooking
implement. Keep people and animals away while backing-up
to implement or pulling away from implement. Do not operate
hydraulic controls while a person or animal is directly behind
the power machine or near the implement.
WARNING
!
To avoid serious injury or death:
The ball detent pin must be fully inserted into the park jack
with ball visible and popped out on the far side of the jack
before working on or around an unhooked cutter.
22265
Tractor Hookup to Bar-Tite Hitch
Figure 1-11
1.
Make certain park jack (#3) is properly attached to
cutter hitch and secured with detent pin (#8). If park
jack is not vertical, refer to
2. Store center 3-point link in the tractor storage hook.
3. Start tractor, raise 3-point arms fully up, and carefully
back tractor within close proximity of clevis (#9).
4. Shut tractor down properly before dismounting. Refer
to
5. Verify tractor drawbar is adjusted correctly. Refer to
6. Raise or lower park jack (#3) to align swivel
clevis (#9) with bolt hole in hitch bushing (#7).
7.
Restart tractor and back tractor up to swivel
clevis (#9) until hole in hitch bushing (#10) aligns with
holes in swivel clevis (#9).
8. Shut tractor down properly before dismounting.
9. Insert 1" x 6 1/2" GR5 hex bolt (#1) through swivel
clevis (#9) and hitch bushing (#7). Secure hex bolt
with locknut (#2). Tighten locknut snugly to remove
all play.
Do Not
torque 1" locknut.
10. Lower park jack (#3) until hitch weight is supported
by the drawbar.
11. Remove park jack (#3) from the hitch and attach it to
the weight box with detent pin (#8). Make sure jack
base is level or lower than the jack crank head. See
cover picture for correct positioning.
12. Attach hitch safety chain (#4) to the tractor. Adjust
chain length to remove all slack except what is
necessary to permit turning. Securely lock chain
hook to the safety chain.
13. Continue with
35549
IMPORTANT: