LANCOM VP
-
100
쮿
Chapter 2: Basic configuration of the LANCOM VP
-
100
14
EN
쮿
Registration will succeed if the information agrees with an active entry for
a SIP user. If this is the case then the telephone displays its name as
'VP-100'.
쮿
If registration is not possible with the data you entered, the device
displays the message 'Register Error'. In this case, check and correct your
entries by using the web interface.
2.2
Basic configuration with the web interface
2.2.1
Open the web interface for configuration with LANconfig
LANconfig, the management software for LANCOM products, also supports
the LANCOM VP-100 Voice over IP telephones. After installation of the
hardware, the LANCOM VP-100 is displayed in the list of devices under a name
consisting of the model type and MAC address.
Clicking with the right-hand mouse key on the device opens up a context
menu which, among other things, can be used to start a web browser for
configuring the device.
2.2.2
Opening the web interface for configuration
The factory settings allow the LANCOM VP-100 to automatically obtain an IP
address by DHCP. Once started, the device displays its current IP address.
햲
If you cannot read the IP address after starting the device, use the menu
key
and the key
to reach the menu entry 'Network settings' and
select with the
key. Use the key
to select the menu entry 'IP
address' and confirm your selection with the key
. You will see the
current IP address for the device in four blocks of three figures.
Summary of Contents for VP-100
Page 1: ...LANCOM VP 100...
