Lamtec FMS Series, Quick Reference For End User

Page: 6 / 74

5
1 General Infomation
However, any other automatic flame guard tested in accordance with DIN EN 298 and/or DIN
EN 230 and approved for continuous operation may be used instead of this.
Before using a flame sensor / flame monitoring system you have to study the associated man-
ual. Pay attention to the specifications and observe the instructions.
Electrical connection to appliances not mentioned in these instructions Only after consultation
with the manufacturers or a qualified expert.If an automatic flame guard not approved for con-
tinuous operation is connected, approval of the system for continuous operation will lapse.Li-
ability for proper functioning of the appliance passes to the owner or operator. Liability for
correct functioning of the appliances in every case passes to the owner or operator, should the
appliance be incorrectly operated, serviced or repaired by persons without the requisite knowl-
edge, or if operation is inconsistent with the specified intended purpose.
In the event of modifications to the unit the type approval lapses. The unit's inputs and outputs
and associated modules must only be wired according to the specifications in these instruc-
tions.
LAMTEC GmbH & Co KG will not be liable for damage or injury arising out of a failure to ob-
serve the instructions above. The warranty and liability provisions of the terms and conditions
of sale and supply of LAMTEC GmbH & Co KG shall not be extended by virtue of the instruc-
tions above.
LAMTEC GmbH & Co KG will not be liable for damage or injury arising out of a failure to ob-
serve the instructions above. The warranty and liability provisions of the terms and conditions
of sale and supply of LAMTEC GmbH & Co KG shall not be extended by virtue of the instruc-
tions above.
Where reference is made to legislation, government regulations and standards, these are
based on the legal system of the Republic of Germany