Lampert Tools USA
2020
27
A-2. ADDITIONAL SYMBOLS FOR INSTALLATION, OPERATION, AND MAINTENANCE
FIRE OR EXPLOSION hazard.
- Do not install or place unit on, over, or near combustible
surfaces.
- Do not install unit near flammables.
- Do not overload building wiring
–
be sure power supply
system is properly sized, rated, and protected to handle
this unit.
FALLING UNIT can cause injury.
- Use lifting eye to lift unit only, NOT running gear, gas
cylinders, or any other accessories.
- Use equipment of adequate capacity to lift and support
unit.
- If using lift forks to move unit, be sure forks are long
enough to extend beyond opposite side of unit.
OVERUSE can cause OVERHEATING
- Allow cooling period; follow rated duty cycle.
- Reduce current or reduce duty cycle before starting to
weld again.
- Do not block or filter airflow to unit.
STATIC (ESD) can damage PC boards.
- Put on grounded wrist strap BEFORE handling boards
or parts.
- Use proper static-proof bags and boxes to store, move,
or ship PC boards.
MOVING PARTS can cause injury.
- Keep away from moving parts.
- Keep away from pinch points such as drive rolls.
WELDING WIRE can cause injury.
- Do not press gun trigger until instructed to do so.
Summary of Contents for PUK U5
Page 1: ...Operating manual PUKU5 ...
