Lampert Tools USA
2020
14
6.6 FIXATION WELDING
>>> THE FIXATION WELDING MENU CAN BE ACTIVATED FROM THE "SETTINGS" USER LEVEL.
After activation (see
also
point
5.5
/
Settings), the fixation
mode appears as a
separate user level,
which
can
be
accessed by pressing
the rotary controller several times for 1 sec. or
permanently.
This mode is used for the fixation of two work piece parts.
See also Chapter 7.3.1.
For using the fixation mode the foot switch is required
(optional accessory).
PLEASE NOTE: FIXATION WELDING IS PARTICULARLY WELL SUITED FOR METALS WITH LOW
ELECTRICAL CONDUCTIVITY, FOR EXAMPLE: TITANIUM AND STEEL.
6.7 MICRO
>>> THE MENU MICRO CAN BE ACTIVATED FROM THE "SETTINGS" USER LEVEL.
The micro menu can
be activated in the
settings user level.
After activation, the
micro menu appears
as a separate user
level, which can be
accessed by pressing and holding the multifunctional
controller.
In micro menu the welding paratmeters can be adjusted
much finer allowing the welding of wires and sheets with
material thickness down to less than 0.2 mm with even
greater control.
6.8 RESISTANCE WELDING MODE
The resistance welding mode appears as a separate user
level, which can be
accessed
by
pressing the rotary
controller
several
times for approx. 1
second.
The welding process is released via the foot switch
(optional accessory) which is permanently activated in this
welding mode.
7. WELDING INSTRUCTIONS
NOTE!
PRIOR TO WELDING, ALWAYS CHECK THE FUNCTION
OF THE EYE PROTECTION FILTER AS DESCRIBED IN
CHAPTER
5.5
"FILTER
TEST".
IF
THE
EYE
PROTECTION FILTER (SHUTTER) FAILS TO SWITCH
OVER FROM LIGHT TO DARK, THEN IT MUST BE
IMMEDIATELY
EXCHANGED
BY
SPECIALIST
PERSONNEL.
7.1 WELDING INSTRUCTIONS
•
First connect a metallic blank section of the workpiece
with the contact clamp.
•
Lightly touch the area to be welded with the tip of the
electrode until welding is carried out. In doing so, it is
important to remain in the position where initial contact
is made until welding begins, i.e. neither to follow the
electrode with the workpiece if it retracts slightly in the
handpiece, nor to pull back.
The welding process starts automatically as soon as the electrode touches the workpiece:
•
Shielding gas flows around the welding area.
•
A signal tone (if activated in the settings) notifies of the
arc.
•
The welding protection filter is darkened.
•
The arc is triggered with a slight delay and the
electrode partly withdraws into the handpiece.
•
The welding protection filter is lightened and the
electrode returns to the initial position.
•
The shielding gas supply stops or the welding process
is started again by touching the workpiece.
WORK ONLY WITH EXTREMELY LIGHT CONTACT AND WITHOUT ANY PRESSURE TO THE TIP OF THE
ELECTRODE!
Summary of Contents for PUK U5
Page 1: ...Operating manual PUKU5 ...
