11
to prolong the battery life. The standard life cycle of a lithium ion battery is 500 cycles.
The battery will fully charge in approximately 10-12 hours. The battery is designed to be
charged overnight and should be charged indoors only. The battery is rated at 12 V and 8.1
AH capacity. Power the meter from the battery pack or from AC power. The USB cable and
AC adapter are used to plug the meter into an AC outlet. WARNING: only use the AC adapter
supplied with this equipment. Do not substitute.
The battery charge status is indicated by the battery icon on the display. The battery icon
will indicate when the battery charge is full, partial, low, empty or charging. The empty
battery icon will fl ash to indicate that meter should be connected to AC power source. If the
meter continues to be used at low battery power without connecting it an AC power source,
the meter will go into an auto-shutdown mode. In this mode the meter will be locked until
meter is connected to an AC source and the battery is charged to a suffi
cient voltage. While
charging, the charging battery icon will be displayed. The meter should
remain plugged in until the battery is fully charged. When the battery is
completely charged, the charging icon will change to the full battery
icon.
SETTINGS
Tap
to enter the SETTINGS menu. Tap
to return to the test screen at any time.
Brightness
The brightness level of the display can be adjusted from 00 to 10. Tap
and
to adjust the brightness. Tap
to exit to the Settings menu.
Date/Time
The Year, Month, Day, Format, Hour, Minute, AM/PM can be set. Tap
or
to adjust the displayed value. Tap
to move to the next value. After
the last value has been chosen (minutes for 24 hour format, AM/PM for
12 hour format) tap
to return to the Settings menu. Tap
to exit to
the Settings menu at any time.
Set
Language
There are ten language options – English, French, Spanish, German,
Dutch, Swedish, Portuguese, Italian, Turkish, Chinese. Tap selection. Tap
to exit to the Settings menu.
Calibration
Tap to run an angle calibration to evaluate the alignment of the hub and
disk. Tap
to exit to the Settings menu.
Power
Options
There are three power options: Auto Dim Time, Auto Off Time, and Power.
Tap the options then tap a selection. Tap selection. Tap
to exit to the
Settings menu.
Bluetooth
There are two Bluetooth options: Bluetooth Enabled and Fast Printer
Connect that are used to print test results. Tap
to exit to the Settings
menu.
GENERAL OPERA
TING PROCEDURES