lamber LP6-ek, Instruction Manual

Page: 12 / 43

12
- lamp 2 flashing – medium cycle 5 minutes
- lamps 1 and 2 lightening at the same time
long cycle of
7 minutes .
The washing period cycle has to be chosen
regarding the dirt that has to be removed.
F – Close the door of the ware-washer.
Push the button cycle “
C ”
The dishwasher starts the washing with the
period you chosen. Additional to this period
will be a pause of 5 seconds and final
rinsing period of 35 seconds with clean
water about 85° to 90°C.
The control cycle lamp is flashing up to the
end of the complete washing period. Finished
the washing period the control lamps will stop
lightening.
Only for machines with steam condenser!
At the end of the washing, the steam suction
fan starts running automatically. The suction
continues for a time that can be programmed
from 5 to 80 seconds after the rinse end (as
default 20’’).
For the programming, look at the specific
paragraph in the installer section.
Cycle lamps flash till the completion of the
final phase of steam ventilation/suction.
At the end of the cycle, the lamps stop
flashing and an acoustic signal, with a
maximum duration of one minute, informs
that it is possible to open the door.
(Attention! During the cycle, at the door
opening also the steam suction fan starts
running for a maximum time of 20 seconds).
It is possible to interrupt the washing cycle at
any time simply pushing again
button “B”.
The lighting of the control lamp “D” means
that the water reached the needed
temperature of 85° to 90°C.
The
rinsing will start working of by the
reached temperature need. That means the
period of the washing cycle you chosed will
be extended up to having reached the exact
temperature (thermocontrol).
G - Take away the basket .
In order to make washing keep on,
load another basket and press pushbutton
"C" . The cycle will automatically start
again.
- Endless cycle (maximum 15 minutes) :
the door being closed and the cycle put on
(any cycle), keep the button
“B” pressed for
3 seconds: lamps 1 and 2 will flash at the
same time (thermocontrol excluded); the
cycle can be interrupted at any time pressing
again button
“C” that will let final sequences
start.
-
Self-washing cycle : Remove the
overflow from the tank and close the
warewasher door while the machine is on
(time 10 minutes).
DURING WASHING
1)
When the machine is running never
change wash time selector position.
2) Only use specific anti-frothing
detergents
3)
Deactivate the equipment in case of
fault or malfunction. For repairs, only
address to a technical assistance center
authorised by the manufacturer and impose
the use of original spare parts.
If these conditions are not met, the
equipment safety could be jeopardised.
ACHIEVEMENTS
Any deficiency in the washing process is
apparent when dirty residuals are visible.
Any halos might be caused by an
insufficuent rinsing: in this case, check that
the rinsing jets are clean and there is a
sufficient pressure in the water distribution
network.
In the case that residuals are present,
check that:
• the washing jets are clean
• there is detergent
• the pump suction filter is clean
• the positions of the objects in the rack are
correct.