lamber LP6-ek Instruction Manual Download Page 7

Page: 7 / 43

INTRODUCTION

ENGLISH

AND SAFETY NORMS

INTRODUCTION

The machines are Industrial pot-washing machines.

Noise level of the machine, less than 70 dB(A).

PRELIMINARY OBSERVATION

Carefully read the instructions reported in the present user manual, as it gives important indications about
safety of installation, operation and maintenance:

carefully keep the present manual for further consultations;

the illustrations and drawings showing the machine are intended for general reference only and are
not necessarily accurate in every particular;

the dimensions and characteristics of the machine, given in this Manual, are not to be considered
binding and may be changed without prior notice;

having removed the packing material, check that all the equipment is present. If there is any doubt, do
not use it and contact qualified personnel. The packing elements (plastic bags, nails, etc.) should be
kept away from children, because they are dangerous.

This appliance in not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance (EN 60335-2-102/7.12).

GENERAL SAFETY REGULATIONS

THIS SAFETY CODE HAS BEEN COMPILED IN YOUR INTEREST. Strict adherence to these rules will
reduce the risks of injury both to yourself and to others;

Personnel working with this machine must adhere strictly to all statutory safety regulations as well as the
specific rules listed below. Failure to do so may result in personal inyury and damage to the machine;

-

DO NOT attempt to move, install, set-up or operate this machine until you have read and fully
understood this Manual. If doubt persists, ask your supervisor;

never leave tools, parts or other loose material on or in the machine;

Before switching the equipment the equipment on, make sure that the model plate data conforms to
that of the electrical and water distribution network;

remember that even with the mains isolator in the “OFF” position, the incoming cables are still live;

BEFORE starting machine o cycle, after any maintenance or repair work, make sure all protective are
correctly installed;

be vigilant at all times, remember that your safety and that of your fellow workers depend on you;

when moving or lifting the machine, care must be taken to comply with all the relevant regulations
governing such operations;

installation should be carried out by qualified personnel according to the manufacturer's instructions.

this equipment should be destined to the use which it has been conceived for. Any other application
should be considered improper and consequently dangerous;

the equipment should only be used by personnel trained for its use;

Repeat regularly the training courses to avoid injury.

Do not open the door when the machine is working. There is a risk of splashing boiling water
impregnated with detergent;

When the door is open and the machine is on, do not immerse your bare hands in the washing tank;

The machine must not be installed in areas at risk of explosion, freezing or not constructed in
accordance with local health and safety norms.

Touch the control screen only with your fingers, avoiding the use of sharp objects.

At the end of the working day turn off the water tap and turn the master switch off.