Lampert Werktechnik GmbH
OPERATING MANUAL PUK D5
6.4 Touch display
The smoothing mode
(1)
and welding situation
(4)
functions can be selected directly via the touch display
by tapping with the finger. The power scale
(2)
, time scale
(3)
and material selection
(5)
can be changed with
the swipe function on the touch display. The recommendation scale
(7)
shows the recommended setting range.
In the red range, the settings are no longer expedient and there is a possible risk of damaging the workpiece.
The foot switch
(6)
can be activated by pressing it for 2 seconds.
6.5 Navigating through operation
Navigation through the user levels takes place by pressing and holding the multifunctional controller for longer
than 1 second. When you do so, the system runs through the following user levels as an endless loop.
When the controller is released, the display comes to a stop at the selected user level. Pressing and holding
again changes to the next user level. It is now possible to implement or check further settings.
6.6 Start menu
In the start menu user level, it is possible to start
welding immediately. At the top edge of the display
it is possible to select the welding material,
and at the lower edge you can select
the geometries or welding situations.
With the help of the swipe function it is possible to
select the most common groups of dental alloys.
The activated material is shown in blue.
(6)
Foot switch
(5)
Material selection
(1)
Smoothing mode
(4)
Welding situation
(3)
Time scale
(2)
Power scale
(7)
Recommendation scale
17
