50
All bearings are sealed for life and do not require any maintenance. If a bearing
becomes faulty, replace it.
The bandsaw is made from steel and cast iron. All non-painted surfaces will rust if
not protected. It is recommended that the table be protected by coating with wax if
the machine is not in constant use. All moving non-painted surfaces (guides, rack
and pinion, etc.) should be lubricated/protected with a Teflon-based lubricant.
The top guide when moved vertically tracks the blade and comes factory-set.
Adjustment is provided should that mechanism become misaligned. This is a
tricky operation and should only be attempted if an extreme error has occurred.
1.
Four clamping bolts and two Allen
jacking screws are provided.
2.
Slightly loosen the clamping bolts.
3.
Tightening the top Allen screw will bring
the guide forward. Loosening the bottom
Allen screw will bring the guide back.
4.
Make only very small adjustments.
Tighten the clamping bolts prior to
checking the guide vertical movement.
Note:
The machine comes factory-set,
and no adjustment should be required.
1.
Check that the start switch is being fully pulled out.
2.
Check that the yellow safety plug is fully engaged.
3.
Check that the electrical power cord is plugged into the power outlet.
4.
Check that the electrical supply is on (reset the breaker).
5.
Check that you have the correct power, 110V not 220V
Allen jacking screws
Clamping bolts
Bearings
Rust
Blade guide rack and pinion
Back guide forward/back adjustment
Bandsaw will not start
Summary of Contents for 14-Twelve Bandsaw
