26
Fixing screws and cable clips
Light fitted in
position
Suggested cable route
Light plugged into
110v socket
The light is fitted to the top of the bandsaw as shown. The light is supplied with a
110-volt three-pin plug. The cable must be held in position with the clips provided
and positioned so that the cable is safe and will not in any way come close to the
blade or cabinet door. Below is the suggested cable route. Use the sticky cable
clamps to secure the cable along the top of the bandsaw. Ensure that the cable is
not over the vertical shaft hole, as it could be damaged when the shaft exits the
hole.
Read and understand the instruction manual before operating the saw.
1.
If you are still not thoroughly familiar with the operation of the bandsaw, get
advice from a qualified person.
2.
Make sure the machine is properly grounded and that the wiring codes are
followed.
3.
Do not operate the bandsaw while under the influence of drugs, alcohol or
medicine or if tired.
4.
Always wear eye protection, safety glasses or a safety shield, and hearing protection.
Before starting the machine
Testing the Bandsaw
Fitting the optional light
Summary of Contents for 14-Twelve Bandsaw
