15
CONNECTING AIR TO THE MACHINE
The input air regulator regulates the air
pressure that is supplied to the machine.
You will require an air supply that can deliver a
constant minimum pressure of 6.5 bar. The
input air regulator will need to be adjusted to
6.5 bar once you have connected your air
supply to the machine.
Note:
No air pipe is supplied, as the length will
depend on your installation.
To adjust the air pressure, pull the cap out and
rotate until the gauge reads the correct
pressure. Once the pressure is adjusted, push
the cap in.
Note:
An air supply of 6.5 bar minimum is
required for the machine. It is strongly recommended that 7 bar be supplied to
the machine and that the regulator then be set to 6.5 bar. This will ensure that
the machine always has the minimum required air pressure. The input regulator
has a moisture trap that must be emptied each day.
Note:
It is important that the air that is supplied to the machine is clean and dry.
The machine will not perform consistently if the air is dirty, as any dirt will block
the valves. Wet or damp air will damage your machine and cause inconsistent
performance.
Note:
The pneumatic system does not need any type of lubricant. Some types of
lubricant can damage the machine and compromise the machine’s functions.
Note:
During maintenance, always disconnect the air supply.
BEFORE STARTING THE MACHINE
1
. Read and understand the instruction
manual before operating the machine.
2.
If you are still not thoroughly familiar with
the operation of the machine get advice from
a quali ed person.
3.
Make sure the machine is properly
grounded and that the wiring codes are
followed.
4.
Do not operate the machine if tired or
while under the in uence of drugs, alcohol, or medicine.
5.
Always wear eye protection, safety glasses or a safety shield, and hearing protection.
6.
Wear dust mask, long term exposure to the ne dust created by the machine is
not healthy.
7.
Remove your tie, rings, watch, and all jewelry. Roll up your sleeves never wear
any loose tting clothing, you do not want anything to get caught.
Air regulator
Control Panel
Summary of Contents for MDM2030-0148
