Laguna Tools MDM2030-0148, Manual

Page: 14 / 50

14
bolts so that the table is level in both directions. Ensure that the machine does
not rock.
ELECTRICAL CONNECTION
Note. The machine is not supplied with
an electrical plug, as the type of plug will
be dependent on the installation.
A quali ed electrician must carry out the
electrical installation.
FITTING THE ELECTRICAL CABLE
The electrical
cable is
terminated in the
electrical cabinet
as shown.
The electrical
cable must be
feed through the
cable grommet at
the back of the
machine.
FITTING THE DUST COLLECTION
The machine is supplied with a 5 inch dust
port positioned on the back of the spindle
hood. A 5-inch diameter hose needs to be
connected to a dust collector with a
minimum capacity of 1,000 cubic feet per
minute minimum. The stronger the dust
collector, the better .
Note. Two things are very important to
ensure that the machine performs
consistently. One is the cleanliness of the machine; the other is a clean, dry air
supply. If the dust and chips that are produced by the cutters on the machine are
not removed, they will jam or block the various switches and micro-switches. It is
therefore important that the dust collection works e ciently and is of su cient
power to remove all the dust and chips from the machine.
Cable Grommet
Mains electrical termination point
Dust port