Laguna Tools MDM2030-0148, Manual

Page: 17 / 50

17
10. With the machine running, slowly open the rear access door until the safety
switch cuts the power to the motor. Close the door until the motor has stopped.
11. With the machine running, slowly open the spindle cover until the safety
switch cuts the power to the motor. Close the door until the motor has stopped.
12. If any of the safety switch es fails to operate correctly do not use the machine
until the fault has been corrected.
Before you cut any wood read the
safety rules at the front of this manual
FITTING A CUTTER
1. With the power disconnected from the
machine.
2. Raise the spindle to the maximum
height.
3. Open the spindle hood and remove any
spacers on the spindle.
4. Clean both the spacer rings and the
spindle shaft as debris can change the
installed height of a cutterhead.
5. Select the spacers that are suitable for
the cutter head that you are tting.
Note . Always mount the cutter head as close to the bottom of the spindle as
practical, this will minimize vibration,
reduces stress on the machine and
improve the surface nish of the cut.
6. Fit the cutter head. Ensure that the
cutter is tted for the correct rotation.
Note. When tting the spacers make
sure that the security nut is properly
tted and provides clamping pressure
on the tooling stack. The security nut
ensures that the cutters will not loosen
during operation and motor braking.
7. Tighten the lock bolt.
8. Rotate the cutter shaft by hand to
ensure that it rotates freely and that the
cutters do not contact any part of the
machine including the sliding table, hood
or clamp.
9. Put the lid back in the closed position.
The machine will not start with the cover
open as the safety micro switch will not
be activated.
Selection of cutters
[not supplied with the machine]
Cutter spindle