29
Removing the job from the spoil board
Pry the job off the spoil board with a wide
blade putty knife or something similar.
Fitting the job to the table using the "T" slots
You may find it convenient to clamp the job to the spoil board with the table clamps.
However,
note that this attachment method can only be used if the outside edges are not being machined.
When using the clamps, place a piece of packing under the jacking bolt to protect the bed of
the machine.
Wide blade putty knife Job
Packing Clamp
Summary of Contents for MCNC Swift 60 X 120-0233
