Laguna Tools MCNC Swift 60 X 120-0233, Manual

Page: 15 / 36

15
Electrical connection for the machine
No cable is supplied as this will depend on the local wiring codes and your electrical supply.
Insure that when installing the electrical supply to the machine that 220v single phase is
supplied.
It is recommended that you use a 30 amp breaker.
Wire to Terminal L1 & L2. Terminal L3 is not used.
Note : When wiring the machine to your electrical system, keep your cable as short as
possible and the cable should not be allowed to run along the floor, as this will cause a trip
hazard.
There is a cable that has a female electrical socket for connection to
the water pump.
Note. A qualified electrician must carry
out the electrical installation.
Dust shroud Dust hose
Dust shroud in
different
position Water pump
electrical socket
Main power
isolation switch
Power / earth
terminals
Main power switch