28
6.
Jog the router bit up or press the origin button to move the router bit up and to the origin
point.
Loading a program into the machine
The controller has a USB slot located to the top.
1.
Load your program into your USB drive.
2.
Fit the USB into the USB slot in the controller.
3.
Press the button RUN PAUSE/ DELETE. The display will show U disc.
4.
Press the OK button.
What is in the USB drive will be shown on the screen.
5.
Use the arrow keys to select the file that you need to load into the controller.
6.
Select, then press OK button.
7.
Once the code / program has been downloaded the machine will start to operate.
Note.
Ensure that you are clear of the machine as the spindle will start to turn and could
cause injury.
8.
The router will just cut the surface of the spoil board the distance that you set in the design
software, (
We suggest 1.6mm [1/16”
) and cut the outline of the job. This will give you the
location of the part on the spoil board.
Fitting a job to the spoil board
You can use double-sided tape to attach the job to the spoil board.
If you are using double-sided tape, ensure that the spoil board and
the job are clean and do not have saw dust or chips as this will
affect the ability of the tape to hold the job securely. Only use the
smallest amount of double-sided tape as it will make it easier to
remove the job once machined.
Double-sided tape
inside job outline
Summary of Contents for MCNC Swift 60 X 120-0233
