17
Fitting the touch off puck
The touch off puck plugs into the front of the machine and is
stored in the puck holder.
Fitting the router bit into the router head
Note:
Before changing or fitting the router bit always
disconnect the power to the machine.
Note.
Collets & spindle collet hole must be cleaned regularly.
Ensure that the slots in the collets are free of sawdust as
sawdust builds up and will stop the collet compressing. If the
collet or spindle hole are not clean, the router bit may not run
true and this will affect the performance of your machine.
1.
Select a router bit and its relevant collet.
2.
Fit the collet into the spindle
nut. Press the collet into the
spindle nut until it snaps into place.
Note.
The router bit must not be
fitted into the collet until the collet
has been fitted into the spindle nut.
With the router bit fitted into the
collet the collet cannot compress
and snap into the spindle nut. The
face of the collet and the face of
the spindle nut will be close to flush.
Note.
To remove the collet, hold the spindle nut and press the collet on the side. The collet
will compress and pop out. Do not try to remove the collet while a cutter is fitted as the collet
will not compress and pop out.
Touch off puck plug
Touch off puck holder
Collet fitted to
spindle nut
Spindle nut Collet
Summary of Contents for MCNC Swift 60 X 120-0233
