UNICO 01.07.2019
English / Englisch
1
1.1 FEATURES OF THE MACHINE
In
Figure 1
we have provided the UNICO with the designations of
the most important components. Please take a little time to become
with the machine.
1.2 DESCRIPTION OF THE MACHINE
The edge sanding machine UNICO works with a sanding disc wheel,
which is installed in an attachment. Three attachments in various
lengths can be supplied. The housing of the attachment covers the
actual working zone. A machine handle, which is used to guide the
machine when you are working on your knees, can be installed
depending on the length of the respective attachment. Velcro
sealing tape is used to seal off the working zone from the discharge
of dust. The resulting increased flow speed of the air upon entering
the working zone from outside guarantees constant good suction of
the sanding dust. Inside the attachment, there is a running V-belt,
which is driven via the V-belt pulley of the motor installed vertically
on the fan housing. The two guide rollers, which support the rear
of the machine, are also installed on the fan housing. In front, the
machine rests on the sanding abrasive (three-point support). The
fan housing is provided with two additional drilled holes into which
the machine handle can be screwed if and when required. On the
rear side of the fan housing, a rotating pipe bend fitted to a pipe
union conveys the sanding dust into the dust bag. The dust bag is
fastened to the pipe bend by means of a quick fastener.
The dust bag is suspended from the cable support by means of
a textile loop. This textile loop keeps the connection cable away
from the working zone and is inserted in the holder on the pipe
bend of the machine guiding system. This holder also includes
the Allen key, which is required to replace conventional sanding
discs. The pipe bend can be used to guide the machine when you
are working on your knees. An extension including a handlebar is
installed at the front end of the pipe end and can be used to guide
the machine when you are working in a stooped position or in an
upright position. The extension and the handlebar can be adjusted
as soon as the clamping lever has been opened.
The machine guiding system and the switch box are attached to
the motor. An ON/OFF switch including no-volt release as well as
the rotating and swiveling working light is fitted to the upper side
of the switch box.
Introduction
INTRODUCTION
You have purchased a high-quality product
from LÄGLER
®
. We wish you a great deal
of success with your UNICO. All LÄGLER
®
products are subjected to a thorough
inspection before leaving the factory.
R e a d t h e s e o p e r a t i n g i n s t r u c t i o n s
completely before working with the
UNICO for the first time! These operating
instructions include important information
on occupational safety and will provide
you with answers to many questions
so that you can work with the machine
safely and without any problems. If you
cannot find a specific subject in these
operating instructions, please read
the LÄGLER
®
application technique
manual “Sanding of wooden floors”
(http://www.laegler.com) or contact our
service department, your retailer or your
importer.
5