UNICO 01.07.2019
English / Englisch
Fig. 11
Inserting the extension into the clamping piece
of the pipe bend
(1) and tightening the clamping
lever (2)..
Fig. 15
Undoing the clamping lever on the extension (1)
and tilting the handlebar over into the desired
position (2).
Fig. 14
The extension can also be pushed all the way
down to the fan housing.
Fig. 13
Undoing the clamping lever (1), sliding the
extension to suit your height (2) and tightening
the clamping lever (3).
Fig. 12
Inserting the handlebar into the clamping piece
of
the extension
(1 + 2) and tightening the clamping
lever (3).
4.4 INSTALLING THE EXTENSION AND THE
HANDLEBAR
1
Insert the extension into the clamping piece
of the pipe bend
(fig. 11, 1) and tighten the clamping lever firmly (fig. 11, 2).
2
Insert the long straight end of the handlebar into the clamping
piece
of the extension
(fig. 12, 1 + 2) and tighten the clamping
lever firmly. (fig. 12, 3).
4.5 ADJUSTING THE EXTENSION AND THE
HANDLEBAR
4.5.1 ADJUSTING THE EXTENSION
The extension of the UNICO can be adjusted to suit the height and
body position of any person performing the sanding work:
1
Switch off the machine and pull the power plug out of the
socket!
2
To adjust the handle height, undo the clamping lever at the
front end of the pipe bend (fig. 13, 1).
3
Slide the extension upward or downward (fig. 13, 2). At the
bottom, it is also allowed to rest on the fan housing (fig. 14).
4
Tighten the clamping lever firmly again (fig. 13, 3).
5
To adjust the handlebar, undo the clamping lever at the upper
end of the extension (fig. 15, 1).
6
Tilt the handlebar over into the desired position (fig. 15, 2)
and then tighten the clamping lever firmly again.
4
COMMISSIONING
20