TRIO 01.04.2015
English / Englisch
COMMISSIONING
4
The changing of sanding media is described in:
- Section 5.3.1, Changing the sanding discs
- Section 5.3.2, Conversion to sanding screens
- Section 5.3.3, Conversion to pads
In order to work with milling discs please proceed as
described in
Section 5.4, Working with milling discs
.
CAUTION!
RISK OF INJURY and RISK OF PROPERTY DAMAGE:
•
Make sure the sanding plates are in place correctly! They
must fit tightly on the bearing and slide into place with a
perceptible click!
•
Always use three sanding plates of the same type!
5
Bring the machine back into vertical position so that the
sanding plates are resting flat on floor surface (fig. 7).
6
Release the clamping lever of the handle (fig. 8, 1), adjust
the handle height to your convenience (fig. 8, 2) and pull the
clamping lever back into its prior position (fig. 8, 3).
7
Open the dust bag box by turning the two fasteners upwards
(fig. 9, 1) and open up the movable half of the dust bag box
(fig. 9, 2).
8
Check to make sure the dust bag is placed correctly on the
neck of dust separator (fig. 10,
A
). The side of the dust bag
with the print on it must be facing you (fig. 10,
B
).
4
Fig. 8
Release the clamping lever of the handle (1), adjust
the handle height to your convenience (2) and pull
the clamping lever back into its prior position (3).
Fig. 7
Bring the machine back into vertical position.
Fig. 9
Open the dust bag box by turning the two fasteners
upwards (1) and open up the movable half of the
dust bag box (2).
Fig. 10
Check to make sure the dust bag is placed
correctly on the neck of dust separator (
A
). The
side of the dust bag with the print on it must be
facing you (
B
).
20
