TRIO 01.04.2015
English / Englisch
Fig. 67
Remove the four cap nuts and washers on top of
the dust separator.
Fig. 68
Lift off the upper part of the separator.
Fig. 69
Lift the filter cartridge out of the filter housing.
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
Fig. 70
Make sure the seal sits properly in the filter
cartridge before replacing it in the dust separator.
Fig. 72
Position the upper part of the separator (1 + 2) and
insert it into the filter cartridge (3).
Fig. 71
Slide the filter cartridge onto the four screws from
above.
7
7
Remove the four cap nuts and washers on top of the dust
separator (fig. 67) and lift off the upper part of the separator
in one straight move (fig. 68).
8
Lift the filter cartridge out of the filter housing (fig. 69). Clean
it or replace it by a new one.
7.3.2 MOUNTING THE FILTER CARTRIDGE
1
Before you insert the filter cartridge, make sure the rubber
seals are in the groove on the filter cartridge (fig. 70).
2
Slide the filter cartridge onto the four screws from above
(fig. 71).
Make sure not to damage the filter cartridge!
The
dust separator system will not work properly otherwise.
3
Now the upper part of the separator can be replaced
(fig. 72). Insert the perforated metal into the upper part of
the separator in such a way that it touches the inside of the
ridge (fig. 73, 1).
43
