Lagler Flip, Operation Maintenance Safety

Page: 16 / 60

FLIP
®
01.12.2012
English / Englisch
WORKING WITH THE FLIP ®
5.1 GENERAL APPLICATION TIPS
WARNING!
RISK OF DEATH from electrical shock:
The machine may never be used for wet processing opera-
tions of any kind!
ATTENTION!
• Bear in mind that the FLIP ® operates at very high cutting
speeds! For this reason, there is a risk of burn marks for
finer grit grades!
• Do not apply excessive pressure to the attachment while
sanding! This will significantly worsen the sanding finish
by causing deep scratches or burn marks and could cause
the motor to switch off from overheating!
The FLIP ® is a very versatile machine. The attachment can be
changed in a matter of seconds. The FLIP ® is used for the sanding
of transitions, borders, edges, corners and stairs.
• Deep sanding marks due to the selection of a too coarse grit
grade can be prevented by starting the first sanding operation
with the finest grit grade possible.
• Prevent sanding marks made by previously used grit grade by
adhering to the order of the sandpaper grit grade and never
skip more than one grit grade.
• After replacing the sanding disc, start working in poorly lit
areas of the room in order to remove the initial aggressive-
ness of the sanding medium.
• Always vacuum the floor or stairs thoroughly before the first
sanding operation and after each additional one.
• Clean the wheels of the machine regularly.
Working with the FLIP
®
Fig. 9 Guide the FLIP
®
with both hands.
5
NOTE:
For more information free of charge, please
contact: within Germany
- Telephone: 0800 / 52 34 537
- Fax: 0800 / 48 66 353
within the USA
- Telephone: 800-848-6635
or
- Telephone: 0049 - 7135 - 98 90 - 0
- Fax: 0049 - 7135 - 98 90 - 98
- e-mail: info@laegler.com
- Internet: http://www.laegler.com
You will also find important and interesting
application tips in the LÄGLER
®
application
technique guidelines “Sanding Wooden
Floors” (http://www.laegler.com)!
16