FLIP
®
01.12.2012
English / Englisch
9
CAUSES OF FAULTS
SANDING PROBLEMS
Waves, strips, grooves
•
The floor or stairs were not vacuumed before sanding. The
floor or stairs must always be cleaned thoroughly before the
first and after each additional sanding operation.
•
The sanding disc was not lifted from the floor while the
machine was being started or switched off. Always tilt the
machine backwards slightly before starting it or switching it
off so that the sanding disc is lifted off the floor (
Section
4.3, Starting the machine
and
Section 4.4, Switching off the
machine
).
•
The sanding medium does not have the proper tension. The
tension must be corrected (
Section 5.2, Replacing the
sanding medium
).
•
The sanding medium is damaged or incorrect and must be
replaced (
Section 5.2, Replacing the sanding medium
).
•
The machine setting angle is not correct. The guide rollers
must be properly adjusted (
Section 7.8, Adjusting the
guide rollers
).
•
The wheels are dirty or damaged and must be cleaned or
replaced (
Section 7.9, Replacing the wheels and the guide
rollers
).
•
The V-belt is dirty, damaged or worn-out and must be replaced
(
Section 7.3, Replacing the V-belt
).
•
A pulley is dirty or worn-out and must be cleaned or replaced
(
Section 7.4, Replacing the complete sanding plate
and
Section 7.5, Replacing the motor pulley
).
•
The machine is being moved too slowly and must be sped up.
•
The machine is not being moved in circular motions while
sanding.
•
Too much pressure is placed on the sanding disc while
sanding. Do not press too hard on the attachment while
sanding.
46
Summary of Contents for Flip
