FLIP
®
01.12.2012
English / Englisch
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
7
Fig. 45
Remove the handle.
Make sure that no parts fall
into the motor!
Fig. 43
A: New motor pulley,
B: worn-out motor pulley that must be replaced.
Fig. 44
Remove the four fixing screws of the handle.
7.5 REPLACING THE MOTOR PULLEY
Use only original LÄGLER
®
motor pulleys (part number in
Section 11,
Spare parts
)!
The motor pulley is subjected to increased wear due to the high
motor speed of the FLIP
®
. In order to prevent excessive wearing of
the V-belt, the pulley should be replaced in a timely fashion (Fig. 43).
1
Switch off the machine.
2
Pull the power plug out of the socket!
WARNING!
RISK OF DEATH from electrical shock:
When disassembling the motor, the power plug must always
be removed from the socket!
3
Undo the four fixing screws of the handle (Fig. 44) and remove
it from the motor housing (Fig. 45).
Make sure that no parts
fall into the motor when doing so!
4
Remove the attachment from the machine (
Section 7.3.1,
Removing the V-belt
).
5
Lay the motor on its side.
6
Hold one end of the motor shaft tightly with an SW 10 span-
ner (Fig 46, 1.) and use a pair of pliers to unscrew the motor
pulley from the motor shaft (Fig 46, 2.).
7
Clean the threads of the motor shaft and the contact surface
of the motor pulley carefully.
8 IMPORTANT:
Oil the inside of the motor pulley drill hole.
9
Turn the new motor pulley onto the motor shaft (Fig. 46, 3.).
Fig. 46
Hold the end of the motor shaft with a spanner (1.)
and unscrew the motor pulley from the shaft (2.).
Screw on the new motor pulley (3.).
30
Summary of Contents for Flip
