FLIP
®
01.12.2012
English / Englisch
Fig. 41
Insert the V-belt into the motor pulley.
7
Tighten the two screws for connecting the attachment, plac-
ing a washer and guide angle in the respective threads of the
fan housing (Fig. 42, 1.). Do not tighten the screws yet.
WARNING!
HEALTH RISK caused by dust:
Make sure that the belt tightening plate is not located between
the attachment and the fan housing (Fig. 42, 2.)! Otherwise, a
significant amount of dust will escape from this area during
sanding!
8
Tighten the V-belt (
Section 7.2, Tightening the V-belt
).
Checking the belt tension again after break-in time of a few days
and tighten the V-belt again if necessary!
7.4 REPLACING THE COMPLETE SANDING PLATE
Use only original LÄGLER
®
sanding plates (part number in
Section 11,
Spare parts
)!
If it is determined while replacing the V-belt that the sanding plate
pulley is worn-out, the complete sanding plate must be replaced
as follows:
1
Switch off the machine.
2
Pull the power plug out of the socket!
3
Remove the attachment from the machine and dismantle the
complete sanding plate (
Section 7.3.1, Removing the V-
belt
).
4
Put the attachment with a new complete sanding plate back
on the machine (
Section 7.3.2, Installing the V-belt
).
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
7
Fig. 42
Turn both screws for connecting the attachment
and place a washer and a guide angle in the
respective thread of the fan housing (1.). Make
sure that the belt tightening plate is not located
between the attachment and the fan housing (2.)!
29
Summary of Contents for Flip
