Lacon L-EX73000, Quick Start Manual

Page: 142 / 184

Hardened Managed Ethernet Switch
142 User’s Manual
affected.
VLAN_NAME The ASCII name of the VLAN. Maximum length: 16
characters.
enable Sets VLAN into an enable state.
disable Sets VLAN into a disable state.
4. Example:
The following example enables the vlan VLANID (
2
) and name VLAN_NAME
(
vlan2
) of bridge GROUP (
1
):
switch_a(config-vlan)#vlan 2 bridge 1 name vlan2 state enable
switch_a(config-vlan)#
802.1Q Port Setting
Switchport mode access:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use
switchport mode access
command to set the switching characteristics
of the Layer-2 interface to access mode, and classify untagged frames only.
Use the
no switchport access
command to reset the mode of the Layer-2
interface to access (default).
3. Command
Syntax:
switchport mode access
no switchport access
4. Example:
The following example sets the
switchport mode access
of the interface fe1
(port 1):
switch_a(config)#interface fe1
switch_a(config-if)#switchport mode access
switch_a(config-if)#
Switchport mode hybrid:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.