Lacon L-EX73000, Quick Start Manual

Page: 134 / 184

Hardened Managed Ethernet Switch
134 User’s Manual
Use the
no spanning-tree edgeport
command to set a port to its default
state (not an edge-port) and to disable rapid transitions.
3. Command
Syntax:
(no) spanning-tree edgeport
4. Example:
The following example enables the
spanning-tree edgeport
of the interface
fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree edgeport
switch_a(config-if)#
MSTP Properties
Region Name:
1.
Command Mode: MST Configuration mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to MST Configuration mode.
The
switch_a(config-mst)#
prompt will show on the screen.
switch_a(config)#spanning-tree mst configuration
switch_a(config-mst)#
2. Usage:
Use this command to create an MST region and specify a name to it. MST
bridges of a region form different spanning trees for different VLANs. By
default, each MST bridge starts with the region name as its bridge address.
This means each MST bridge is a region by itself, unless specifically added to
one.
3. Command
Syntax:
bridge GROUP region REGION_NAME
no bridge GROUP region
GROUP <1-1> Specify the bridge-group ID.
REGION_NAME Specify the name of the region.
4. Example:
The following example creates an MST region and specifies a name
(
regionname
) to it in bridge GROUP (
1
):
Switch_a(config)#spanning-tree mst configuration
switch_a(config-mst)#bridge 1 region regionname
switch_a(config-mst)#
Revision Level:
1.
Command Mode: MST Configuration mode
Logon to Configure Mode (Configure Terminal Mode).