16
14.
Sum Run Time Checking
The total run time of current operation can be checked via following steps. Run time starts
counting once "Start/Stop" button is pressed, and stops when pressed again.
14.1 Press "Set/Confirm" button and press the "Increase" button to "10", then press "Set/Confirm"
button again to see "Sum Run Time".
14.2 This is the accumulated time of current operation, which cannot be changed.
15.
Operation and Switch off
15.1 When all the above settings are done, press the Start/Stop button and the equipment will run
according to the stored settings.
15.2 When during operation, the Start/Stop button is pressed, the platform stops from shaking
temporarily. The operation time remains on hold.
15.3 Press the Start/Hold button again to resume operation, the pre-set time starts to count down from
the remaining time when the operation was stopped.
15.4 When during operation, if the Start/Stop button is held on, within 3 seconds the remaining
operating time will be cleared to zero. Press the Start/Stop button once more, and the unit starts
again to count down from the preset operation time.
15.5 While the unit is in use, the current remaining operating time cannot be changed. If however
changed at this time, it is invalid with the current operation. Only when the current operation has
passed or stopped according to the above method, only if the instrument is re- started the new
changed value will be effective.
15.6 The equipment can be turned off by holding on the Power button on the control panel for 2
seconds. At this time, the control board is still connected to the power supply, so the main switch
on the right side of the equipment must be shut off to end operation completely.
Special Attention!
The communication address is used as an identifying code for
each unit to pair with the software of the PC terminal. Each
communication code must be connected to only one unit. Different
communication addresses must be used if multiple units are to be
connected to the same PC terminal.
10
Check Sum Run Time
Exit
