S1 Dream-T Espresso Machine
Owner’s Manual
Page 7
To create a user profile the machine should be turned on and up to temperature. To access
the menu press and hold the
button for approximately 3 seconds until the menu appears on
the display. Then use the down arrow key to cycle through the menu until the display reads
PROGRAM
and then press the
button to enter the program menu.
Once in the program menu you can use the arrow key to cycle through the user profiles.
USER1
will be the default user and should be programmed first. Press the
button to select
and program
USER1
. Once in the
USER1
profile you can cycle through the various options
available for programming and then press the
button to select that option to change. The
following parameters can be changed in the user profiles menu.
Coffee Temperature
Use the arrow keys to select the desired brew temperature and then
press the
button to save the setting. The recommended brew temperature is between 200-
204°F, but can be easily changed to match the coffee you are using. Experiment until you find
the temperature your coffee tastes best at.
Boiler Temperature
Use the arrow keys to select the desired steam boiler temperature and
then press the
button to save the setting. The recommended steam boiler temperature is
between 250-260°F. Going too low in temperature may cause a loss of steam pressure.
Coffee Doses
To program the coffee doses fresh coffee must be prepared for each button that
is programmed and the machine should be up to temperature. To program a coffee dose,
prepare and tamp the coffee and lock the portafilter into the grouphead. Whichever portafilter
you have in the grouphead press the corresponding
/
button to start the programming.
When the shot has reached the desired level then press the same
/
button again to
stop the shot and save the new setting. Repeat the above step to program the other shot
button. The recommended size for a single shot is 1oz and 2oz for a double shot, but can be
fine tuned to your particular tastes.
Creating User Profiles - Continued
Hot Water
The hot water faucet can be programmed to work in auto or manual mode. In the
profile menu select the hot water faucet icon. You have the option to select auto or manual
mode and then press the
button. For manual mode the hot water button must be pressed to
start water delivery and then pressed again to stop delivery. In auto mode the hot water
delivery will stop at the pre-determined amount. By default it is set to 5 seconds. To program
the faucet for auto mode, after selecting auto mode in the menu a screen will be displayed
showing 5sec. Press the hot water button to start delivery and when the water has reached the
desired level press the button again to stop delivery and save the new setting. The new setting
will now be saved and 1 press of the hot water button will give the programmed amount each
