S1 Dream-T Espresso Machine
Owner’s Manual
Page 9
Backlight LCD
This enables the user to select the timeout feature to turn the display off when
not in use.
Timer
The timer feature allows the user to have the machine be turned on and off at 3 different
time intervals throughout the day and also have each day programmed differently or not at all if
you do not want the machine turned on that particular day. Each day will have 3 different on/off
time slots to be programmed. If a time has been programmed into the timer that you no longer
want to turn on that time of the day then if you set the on and off times at the same time then it
will zero out that setting and no longer be active.
Counters
The counters keep track of the amount of drinks being dispensed. To reset the
counters while in the counters menu arrow down to reset and then press the
button.
Program
Allows the user to program user profiles such as coffee temperature, volume, etc.
Service
This feature when enabled will give an alarm message on the display to indicate the
machine is due for service. This can be set at different service intervals based on drink cycles.
Filter
This feature when enabled will give a message to indicate that the filter needs to be
replaced. By default the filter counter will give a message after 27 gallons of use. Depending
on the hardness of your water you may get more or less use from the filter. For an accurate
indication of the filter lifespan, check your water for hardness and then use the chart on page 3
to determine how many gallons can be softened before replacement. To reset the filter alarm,
go into the filter menu and then press and hold the
button and when prompted press the
button again to clear the filter alarm.
Alarms
Gives the status of any active alarms in the machine. Use the arrow keys to cycle
through the active alarms. To reset the alarms press and hold the
button and then when
prompted press the
button again to clear the alarms.
Read
Allows the user to read the contents of the SD memory card.
Features
Write
Feature not active at this time. Will be available in a future firmware update.
LED
The Barista LED lights can be turned on, off, or auto mode. In auto mode the LED’s will
only light up when a shot is being drawn.
Grinding
This feature when enabled will give the user a notice while brewing if the grind is too
fine or coarse. This is helpful to help achieve better results. When enabled the user can set the
grinding for a tolerance of 5, 10, or 15 seconds. So if a shot button is programmed for 25
seconds and the grinding is set to 5 seconds then if the shot runs for less than 20 seconds a
message will appear on the display “Coarse Grind” Adjusting the grind finer will improve the
shots. If the shot runs for more than 30 second
s then the display will show the message “Too
Fine Grind” Adjusting the grind coarser will improve the shots.
